Preliminary Study on Design and Positioning of Color Box Structure

November 23, 2022

Many companies' products always have tearing of the outer packaging during the transportation process, which causes the products in the packaging box to be difficult to remove or fall out. In severe cases, the interior contents may even be broken, causing unnecessary losses to the company. Products that exhibit these phenomena may be a problem with the structure of the package. Designers can avoid this simply by paying a little attention in the early stages of product design.

Freckle pits and E pits are frequently used in micro-stained boxes. The thickness of pit F is about 1 mm, and E pit is 2 mm. The specific thickness also depends on the specific paper on the actual pit paper.

As shown in the figure on the right, the color box structure of the box is the size of the E-box color box and the repair bitmap. The size of the double insert box in the figure is: 10 x 5 x 15, in inches. The main repair dimensions are shown in the figure. In general, the side of the trim box, ie, the width edge is 3/64”, the lid is 3/64” smaller than the width of the box. The front and back of the box are The pressure line is 1/16′′ higher than the pressure line in the direction of the width of the box, which is also known as the high and low lines. This is the main repair point. The remaining Dust flaps can refer to the size of the figure, because the size of the box The changes should be adjusted accordingly. Be careful not to disproportionately adjust them according to your preferences.

The figure shows the different pit paper repairs. The paper thickness refers to the sum of the paper and the core paper in the facial paper. Because we will pick up some thicker paperboard on the top, the thickness is slightly larger than the national standard. This can make the structure design more relaxed. The dimension of the width direction repairing takes into account the fact that the hand-adhesive box is convenient for alignment. It is done according to the standard of 1mm double pits with a single pit of 2mm. This can be applied in practice. The upper auto-adhesive box machine should be adjusted to a paper thickness. Double line width is the paper is folded in 180 degrees, is the width of the two lines, depending on the needs of different box type (the inside may have a sandwich) distance is different, a more common application is the display box as shown below.

The figure shows an E-pit display box. The distance between four folded double lines is 3/16”. The middle partition plate is also folded in half. These are some basic requirements in the normal design, but also some complex structural designs. The foundation is therefore required as a designer to master it.

früher

Kontaktiere uns

Author:

Mr. Darent

Email:

darent@fushanprint.com

Phone/WhatsApp:

+886919713906

beliebte Produkte

Aktuelles